Kramer AVoIP covers switching well; rooms that also need audio processing add separate DSP hardware. The ADHOOPU alternative is one stack: 4K60 endpoints over 1GbE plus integrated DSP, control and matrix in the platform.
Kramer AVoIP encoder and decoder roles map to the QG-FBST52K and QG-FBSR52K: 4K60 over standard 1GbE with HDMI, RS-232, IR and CEC.
The QG-1169H platform carries a full DSP layer — audio matrix, EQ, AEC — so huddle rooms and boardrooms get audio processing without a separate DSP chassis and its cabling.
Open TCP/UDP/HTTP APIs plus a built-in control engine replace the control-platform dependency for everyday logic; your existing panels can keep working through the same APIs.
8 to 32-layer video wall layouts from the platform — lobbies, command walls and menu boards without extra wall-processor hardware.
Three years on every unit, endpoints and platform alike.
A cost structure with genuine integrator margin — priced to close the deal, not just to compare spec sheets.
Specification sheets (PDF): QG-FBST52K encoder datasheet — PDF, 4 pages · QG-FBSR52K decoder datasheet — PDF, 4 pages All product datasheets
In most rooms, yes — the platform exposes open TCP/UDP/HTTP control APIs, so your existing panels can drive switching and layouts through a thin adapter.
For room audio — microphones, AEC, EQ, matrix mixing — yes. For large-scale PA or special installations, both systems can coexist and the platform handles the AV side.
Run ADHOOPU endpoints on a dedicated VLAN, move rooms one by one, and use HDMI bridging between systems during the transition.
ADHOOPU is the Kramer AVoIP alternative that prices the whole room honestly: 4K60 endpoints, integrated DSP instead of add-on audio hardware, control via open APIs, and matrix routing included in the platform. Ask for a project-specific configuration and trial units at factory pricing.
Kramer sells AV over IP under several product names — KDS-7 and KDS-8 for endpoints, KDS-17 for higher-density rooms, plus the control and audio lines that often get bundled into the same bill of materials. Integrators comparing a Kramer AV over IP alternative usually discover the quote contains three purchases: the endpoints, a control processor for room logic, and a DSP for audio. The endpoint price is rarely where the budget goes.
| Layer | Typical Kramer AVoIP bill | ADHOOPU QG-1169H stack |
|---|---|---|
| Endpoints | KDS-7 / KDS-8 encoder and decoder pairs, model chosen per room | QG-FBST52K encoder, QG-FBSR52K decoder, dual-role FBSLTR002/003 where a desk both sends and receives |
| Routing | Software or appliance layer, licensed by node count | Built into the platform — any source to any screen, point-to-multipoint and many-to-many, no node licence |
| Audio | Separate DSP appliance for mixing, AEC and delay | Audio embedded per stream with breakaway and independent routing in the same platform |
| Control | Control processor plus driver development per device type | Open TCP/UDP/HTTP control engine on the platform; existing panels drive it through the API |
| Video wall | Separate wall processing or a licensed tiling feature | Layout presets, bezel compensation and rotation applied on the decoders |
| Warranty | Regional base terms, extended cover quoted separately | 3-year warranty on every endpoint and the platform, factory direct |
The comparison is about architecture and support ownership. Confirm current Kramer model numbers, licensing and warranty terms with Kramer for your region — those details change.
Yes in most rooms. The platform exposes documented TCP/UDP and HTTP commands, so existing panels keep working through a thin adapter layer rather than being replaced. If your panels carry Kramer-specific drivers, budget a day of reprogramming per room type, not per room.
Mixing, gain and routing move into the platform. Room-specific audio processing — AEC on a conferencing input, delay for a distributed ceiling speaker zone — is configured per zone. If a site depends on a bespoke DSP preset, capture it as a documented scene before decommissioning the old appliance.
No. Standard managed switches with IGMP snooping, a media VLAN and QoS carry the streams. This is often the point where the IT team becomes an ally rather than an obstacle, because the AV traffic follows the same rules as the rest of the network.
That is the normal route. Keep the Kramer system serving untouched floors and move room groups across in phases, with both systems visible to the operator during the overlap. Nothing forces a single-night cutover.
Comparing a full bill of materials? These are the other replacement options and equivalent platforms integrators most often weigh against this one.
Platform, endpoints and firmware ownership compared before you shortlist.
One decoder per panel, layout presets on-premise, no proprietary chassis.
Encoder/decoder pairing, bitrate per codec profile, latency budget per stage.
What distribution changes in the design, and who really owns the firmware.
Professional AV manufacturer — Integrated AV Platforms, Distributed AV over IP, and AI Edge Computing & Video Analytics. OEM/ODM for system integrators, distributors and AV brands worldwide.
19 years of AV engineering · Shenzhen, China · 3-year warranty